Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-164
v1.0, July 2010
set mld querier timer expiry
Use this command to set the MLD Querier timer expiration period. It is the time period that the
switch remains in Non-Querier mode once it has discovered that there is a Multicast Querier in the
network.
no set mld querier timer expiry
Use this command to set the MLD Querier timer expiration period to its default value.
set mld querier election participate
Use this command to enable the Snooping Querier to participate in the Querier Election process
when it discovers the presence of another Querier in the VLAN. When this mode is enabled, if the
Snooping Querier finds that the other Querier’s source address is better (less) than the Snooping
Querier’s address, it stops sending periodic queries. If the Snooping Querier wins the election,
then it will continue sending periodic queries.
no set mld querier election participate
Use this command to set the snooping querier not to participate in querier election but go into a
non-querier mode as soon as it discovers the presence of another querier in the same VLAN.
Default 60 seconds
Format set mld querier timer expiry <60-300>
Mode Global Config
Format no set mld querier timer expiry
Mode Global Config
Default disabled
Format set mld querier election participate <vlanid>
Mode VLAN Config
To Next Page
Loading...
