NETGEAR GSM7228PS - Dhcpv6 Commands; Show Ipv6 Ospf Virtual-Link Brief

Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-68
v1.0, July 2010
show ipv6 ospf virtual-link brief
This command displays the OSPFV3 Virtual Interface information for all areas in the system.
DHCPv6 Commands
This section describes the command you use to configure the DHCPv6 server on the system and to
view DHCPv6 information.
Dead Interval The configured dead interval for the OSPF virtual interface.
Iftransit Delay
Interval
The configured transit delay for the OSPF virtual interface.
Retransmit
Interval
The configured retransmit interval for the OSPF virtual interface.
Authentication
Type
The type of authentication the interface performs on LSAs it receives.
State The OSPF Interface States are: down, loopback, waiting, point-to-point, designated
router, and backup designated router. This is the state of the OSPF interface.
Neighbor State The neighbor state.
Format show ipv6 ospf virtual-link brief
Modes • Privileged EXEC
• User EXEC
Term Definition
Area ID The area id of the requested OSPFV3 area.
Neighbor The neighbor interface of the OSPFV3 virtual interface.
Hello Interval The configured hello interval for the OSPFV3 virtual interface.
Dead Interval The configured dead interval for the OSPFV3 virtual interface.
Retransmit
Interval
The configured retransmit interval for the OSPFV3 virtual interface.
Transit Delay The configured transit delay for the OSPFV3 virtual interface.
Term Definition