EasyManuals Logo

NETGEAR GSM7228PS User Manual

NETGEAR GSM7228PS
788 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #528 background imageLoading...
Page #528 background image
Managed Switch CLI Manual, Release 8.0.3
Quality of Service (QoS) Commands 8-41
v1.0, July 2010
keyword ‘any’ to indicate a match on any value in that field. The remaining command parameters
are all optional, but the most frequently used parameters appear in the same relative order as
shown in the command format.
The assign-queue parameter allows specification of a particular hardware queue for handling
traffic that matches this rule. The allowed <queue-id> value is 0-(n-1), where n is the number
of user configurable queues available for the hardware platform. The assign-queue parameter
is valid only for a permit rule.
ip access-group
This command either attaches a specific IP ACL identified by <accesslistnumber> to an
interface or associates with a VLAN ID in a given direction. The parameter <name> is the name
of the Access Control List.
An optional sequence number may be specified to indicate the order of this IP access list relative to
other IP access lists already assigned to this interface and direction. A lower number indicates
higher precedence order. If a sequence number is already in use for this interface and direction, the
specified access list replaces the currently attached IP access list using that sequence number. If
the sequence number is not specified for this command, a sequence number that is one greater than
the highest sequence number currently in use for this interface and direction is used.
Format {deny | permit} {every | {{icmp | igmp | ip | tcp | udp | <number>}
<srcip> <srcmask>[{eq {<portkey> | <0-65535>} <dstip> <dstmask> [{eq
{<portkey>| <0-65535>}] [precedence <precedence> | tos <tos> <tosmask>
| dscp <dscp>] [log] [assign-queue <queue-id>] [{mirror | redirect}
<unit/slot/port>]
Mode Ipv4-Access-List Config
Note: You should be aware that the <out> option may or may not be available,
depending on the platform.
Default none
Format ip access-group <accesslistnumber> <name> [vlan <vlan-id>] <in |
out>[sequence <1-4294967295>]
Modes • Interface Config
• Global Config

Table of Contents

Other manuals for NETGEAR GSM7228PS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR GSM7228PS and is the answer not in the manual?

NETGEAR GSM7228PS Specifications

General IconGeneral
BrandNETGEAR
ModelGSM7228PS
CategorySwitch
LanguageEnglish

Related product manuals