NETGEAR GSM7228PS - Show Captive-Portal Interface Client Status

Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-21
v1.0, July 2010
Example
(switch)#show captive-portal client 0102.0304.0506 statistics
Client MAC Address........................ 0002.bc00.1290
Bytes Received............................ 0
Bytes Transmitted......................... 0
Packets Received.......................... 0
Packets Transmitted....................... 0
show captive-portal interface client status
Use this command to display information about clients authenticated on all interfaces or a specific
interface
If the interface is specified, the following terms are displayed.
Term Definition
Client MAC
address
The MAC address of the authenticated client
Bytes Received The number of bytes received from the client
Bytes Transmitted The number of bytes transmitted to the client
Packets Received The number of packets received from the client
Packets
Transmitted
The number of packets transmitted from the client
Format show captive-portal interface [<unit/slot/port>] client status
Mode Privileged EXEC mode
Term Definition
Client Intf Interface on which the clients are authenticated.
Client Intf
Descripiton
The interface description
MAC Address The MAC address of the authenticated user.
IP Address The IP address of the authenticated user.
Term Definition
CP ID The ID of the captive portal associated with the client
CP Name The name of the captive portal associated with the client
Protocol The protocol the client is using