NETGEAR GSM7228PS - Distribute-List out (Rip); Ip Rip Authentication

Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-85
v1.0, July 2010
no distance rip
This command sets the default route preference value of RIP in the router.
distribute-list out (RIP)
This command is used to specify the access list to filter routes received from the source protocol.
no distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
ip rip authentication
This command sets the RIP Version 2 Authentication Type and Key for the specified interface.
The value of <type> is either none, simple, or encrypt. The value for authentication key
[key] must be 16 bytes or less. The [key] is composed of standard displayable, non-control
keystrokes from a Standard 101/102-key keyboard. If the value of <type> is encrypt, a keyid
in the range of 0 and 255 must be specified. Unauthenticated interfaces do not need an
authentication key or authentication key ID.
Format no distance rip
Mode Router RIP Config
Default 0
Format distribute-list <1-199> out {ospf | static | connected}
Mode Router RIP Config
Format no distribute-list <1-199> out {ospf | static | connected}
Mode Router RIP Config
Default none
Format ip rip authentication {none | {simple <key>} | {encrypt <key>
<keyid>}}
Mode Interface Config