Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-86
v1.0, July 2010
no ip rip authentication
This command sets the default RIP Version 2 Authentication Type for an interface.
ip rip receive version
This command configures the interface to allow RIP control packets of the specified version(s) to
be received.
The value for <mode> is one of: rip1 to receive only RIP version 1 formatted packets, rip2
for RIP version 2, both to receive packets from either format, or none to not allow any RIP
control packets to be received.
no ip rip receive version
This command configures the interface to allow RIP control packets of the default version(s) to be
received.
ip rip send version
This command configures the interface to allow RIP control packets of the specified version to be
sent. The value for <mode> is one of: rip1 to broadcast RIP version 1 formatted packets,
rip1c (RIP version 1 compatibility mode) which sends RIP version 2 formatted packets via
broadcast, rip2 for sending RIP version 2 using multicast, or none to not allow any RIP control
packets to be sent.
Format no ip rip authentication
Mode Interface Config
Default both
Format ip rip receive version {rip1 | rip2 | both | none}
Mode Interface Config
Format no ip rip receive version
Mode Interface Config
Default ripi2
To Next Page
Loading...
