Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-87
v1.0, July 2010
no ip rip send version
This command configures the interface to allow RIP control packets of the default version to be
sent.
hostroutesaccept
This command enables the RIP hostroutesaccept mode.
no hostroutesaccept
This command disables the RIP hostroutesaccept mode.
split-horizon
This command sets the RIP split horizon mode. Split horizon is a technique for avoiding problems
caused by including routes in updates sent to the router from which the route was originally
learned. The options are: None - no special processing for this case. Simple - a route will not be
included in updates sent to the router from which it was learned. Poisoned reverse - a route will be
included in updates sent to the router from which it was learned, but the metric will be set to
infinity.
Format ip rip send version {rip1 | rip1c | rip2 | none}
Mode Interface Config
Format no ip rip send version
Mode Interface Config
Default enabled
Format hostroutesaccept
Mode Router RIP Config
Format no hostroutesaccept
Mode Router RIP Config
Default simple
To Next Page
Loading...
