Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-40
v1.0, July 2010
method1 [method2…] At least one from the following table:
no aaa authentication dot1x
This command is used to remove the authentication at login.
write memory
Use this command to save running configuration changes to NVRAM so that the changes you
make will persist across a reboot. This command is the same as copy system:running
config nvram:startup-config.
SNMP Commands
This section describes the commands you use to configure Simple Network Management Protocol
(SNMP) on the switch. You can configure the switch to act as an SNMP agent so that it can
communicate with SNMP managers on your network.
Keyword Description
local Uses the local username database for authentication.
none Uses no authentication.
radius Uses the list of all RADIUS servers for authentication.
Format no aaa authentication dot1x default
Mode Global Config
Format write memory
Mode Privileged EXEC
To Next Page
Loading...
