NETGEAR GSM7228PS - Show Ipv6 Mld Interface

Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-21
v1.0, July 2010
Up Time (hh:mm:ss)............................. 00:02:53
Expiry Time (hh:mm:ss)......................... ------
Filter Mode.................................... Include
Version1 Host Timer............................ ------
Group compat mode.............................. v2
Source Address ExpiryTime
----------------- -----------
2003::10 00:04:17
2003::20 00:04:17
show ipv6 mld interface
Use this command to display MLD-related information for the interface.
The following information is displayed for each of the interfaces or for only the specified
interface.
Format show ipv6 mld interface [<unit/slot/port>]
Mode • Privileged EXEC
• User EXEC
Field Description
Interface The interface number in unit/slot/port format.
MLD Global
Mode
Displays the configured administrative status of MLD.
MLD Operational
Mode
The operational status of MLD on the interface.
MLD Version Indicates the version of MLD configured on the interface.
Query Interval Indicates the configured query interval for the interface.
Query Max
Response Time
Indicates the configured maximum query response time (in seconds) advertised in MLD
queries on this interface.
Robustness Displays the configured value for the tuning for the expected packet loss on a subnet
attached to the interface.
Startup Query
interval
This valued indicates the configured interval between General Queries sent by a Querier
on startup.
Startup Query
Count
This value indicates the configured number of Queries sent out on startup, separated by
the Startup Query Interval.
Last Member
Query Interval
This value indicates the configured Maximum Response Time inserted into Group-Specific
Queries sent in response to Leave Group messages.