Managed Switch CLI Manual, Release 8.0.3
Quality of Service (QoS) Commands 8-34
v1.0, July 2010
{deny | permit} (MAC ACL)
This command creates a new rule for the current MAC access list. Each rule is appended to the list
of configured rules for the list.
A rule may either deny or permit traffic according to the specified classification fields. At a
minimum, the source and destination MAC value must be specified, each of which may be
substituted using the keyword any to indicate a match on any value in that field. The remaining
command parameters are all optional, but the most frequently used parameters appear in the same
relative order as shown in the command format.
The Ethertype may be specified as either a keyword or a four-digit hexadecimal value from
0x0600-0xFFFF. The currently supported <ethertypekey> values are: appletalk, arp, ibmsna,
ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe, rarp. Each of these translates into its
equivalent Ethertype value(s).
Note: The 'no' form of this command is not supported, since the rules within a MAC ACL
cannot be deleted individually. Rather, the entire MAC ACL must be deleted and
re-specified.
Note: An implicit 'deny all' MAC rule always terminates the access list.
Ethertype Keyword Corresponding Value
appletalk 0x809B
arp 0x0806
ibmsna 0x80D5
ipv4 0x0800
ipv6 0x86DD
ipx 0x8037
mplsmcast 0x8848
mplsucast 0x8847
netbios 0x8191
novell 0x8137, 0x8138
pppoe 0x8863, 0x8864
rarp 0x8035
To Next Page
Loading...
Need help?
General
