NETGEAR GSM7228PS - Sntp Client Mode; Sntp Client Port

Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-35
v1.0, July 2010
sntp client mode
This command enables Simple Network Time Protocol (SNTP) client mode and may set the mode
to either broadcast or unicast.
no sntp client mode
This command disables Simple Network Time Protocol (SNTP) client mode.
sntp client port
This command sets the SNTP client port id to a value from 1-65535.
no sntp client port
This command resets the SNTP client port back to its default value.
Default disabled
Format sntp client mode [broadcast | unicast]
Mode Global Config
Format no sntp client mode
Mode Global Config
Default 123
Format sntp client port <portid>
Mode Global Config
Format no sntp client port
Mode Global Config