NETGEAR GSM7228PS - Set Igmp Querier Query-Interval; Set Igmp Querier Timer Expiry

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-150
v1.0, July 2010
set igmp querier query-interval
Use this command to set the IGMP Querier Query Interval time. It is the amount of time in
seconds that the switch waits before sending another general query.
no set igmp querier query-interval
Use this command to set the IGMP Querier Query Interval time to its default value.
set igmp querier timer expiry
Use this command to set the IGMP Querier timer expiration period. It is the time period that the
switch remains in Non-Querier mode once it has discovered that there is a Multicast Querier in the
network.
no set igmp querier timer expiry
Use this command to set the IGMP Querier timer expiration period to its default value.
Default disabled
Format set igmp querier query-interval <1-18000>
Mode Global Config
Format no set igmp querier query-interval
Mode Global Config
Default 60 seconds
Format set igmp querier timer expiry <60-300>
Mode Global Config
Format no set igmp querier timer expiry
Mode Global Config