Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-206
v1.0, July 2010
show mac-address-table stats
This command displays the Multicast Forwarding Database (MFDB) statistics.
ISDP Commands
This section describes the commands you use to configure the industry standard Discovery
Protocol (ISDP).
isdp run
This command enables ISDP on the switch.
no isdp run
This command disables ISDP on the switch.
Format show mac-address-table stats
Mode Privileged EXEC
Term Definition
Max MFDB
Table Entries
The total number of entries that can possibly be in the Multicast Forwarding Database
table.
Most MFDB
Entries Since
Last Reset
The largest number of entries that have been present in the Multicast Forwarding
Database table. This value is also known as the MFDB high-water mark.
Current Entries The current number of entries in the MFDB.
Default Enabled
Format isdp run
Mode Global Config
Format no isdp run
Mode Global Config
To Next Page
Loading...
Need help?
General
