Managed Switch CLI Manual, Release 8.0.3
IP Multicast Commands 5-8
v1.0, July 2010
no ip dvmrp metric
This command resets the metric for an interface to the default value. This value is used in the
DVMRP messages as the cost to reach this network.
ip dvmrp trapflags
This command enables the DVMRP trap mode.
no ip dvmrp trapflags
This command disables the DVMRP trap mode.
ip dvmrp
This command sets the administrative mode of DVMRP on an interface to active.
no ip dvmrp
This command sets the administrative mode of DVMRP on an interface to inactive.
Format no ip dvmrp metric
Mode Interface Config
Default disabled
Format ip dvmrp trapflags
Mode Global Config
Format no ip dvmrp trapflags
Mode Global Config
Default disabled
Format ip dvmrp
Mode Interface Config
Format no ip dvmrp
Mode Interface Config
To Next Page
Loading...
