Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-70
v1.0, July 2010
The following OSPF NSSA specific information displays only if the area is configured as an
NSSA:
show ip ospf asbr
This command displays the internal OSPF routing table entries to Autonomous System Boundary
Routers (ASBR). This command takes no options.
Area LSA
Checksum
A number representing the Area LSA Checksum for the specified AreaID excluding the
external (LS type 5) link-state advertisements.
Import Summary
LSAs
Shows whether to import summary LSAs.
OSPF Stub
Metric Value
The metric value of the stub area. This field displays only if the area is a configured as a
stub area.
Term Definition
Import Summary
LSAs
Shows whether to import summary LSAs into the NSSA.
Redistribute into
NSSA
Shows whether to redistribute information into the NSSA.
Default
Information
Originate
Shows whether to advertise a default route into the NSSA.
Default Metric The metric value for the default route advertised into the NSSA.
Default Metric
Type
The metric type for the default route advertised into the NSSA.
Translator Role The NSSA translator role of the ABR, which is always or candidate.
Translator
Stability Interval
The amount of time that an elected translator continues to perform its duties after it
determines that its translator status has been deposed by another router.
Translator State Shows whether the ABR translator state is disabled, always, or elected.
Format show ip ospf asbr
Mode • Privileged EXEC
• User EXEC
Term Definition
To Next Page
Loading...
