Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-2
v1.0, July 2010
IPv6 Multicast Forwarder
show ipv6 mroute
Use this command to show the mroute entries specific for IPv6. (This command is the IPv6
equivalent of the IPv4 show ip mcaste mroute command.)
If you use the detail parameter, the command displays the following Multicast Route Table
fields:
If you use the summary parameter, the command displays the following fields:
Note: There is no specific IP multicast enable for IPv6. Enabling of multicast at global
config is common for both IPv4 and IPv6.
Format show ipv6 mroute {detail | summary}
Modes • Privileged EXEC
• User EXEC
Term Definition
Source IP The IP address of the multicast data source.
Group IP The IP address of the destination of the multicast packet.
Expiry Time The time of expiry of this entry in seconds.
Up Time The time elapsed since the entry was created in seconds.
RPF Neighbor The IP address of the RPF neighbor.
Flags The flags associated with this entry.
Term Definition
Source IP The IP address of the multicast data source.
Group IP The IP address of the destination of the multicast packet.
Protocol The multicast routing protocol by which the entry was created.
Incoming
Interface
The interface on which the packet for the source/group
arrives.
To Next Page
Loading...
Need help?
General
