Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-82
v1.0, July 2010
show ip ospf virtual-link brief
This command displays the OSPF Virtual Interface information for all areas in the system.
Routing Information Protocol (RIP) Commands
This section describes the commands you use to view and configure RIP, which is a distance-
vector routing protocol that you use to route traffic within a small network.
router rip
Use this command to enter Router RIP mode.
enable (RIP)
This command resets the default administrative mode of RIP in the router (active).
Format show ip ospf virtual-link brief
Modes • Privileged EXEC
• User EXEC
Term Definition
Area ID The area id of the requested OSPF area.
Neighbor The neighbor interface of the OSPF virtual interface.
Hello Interval The configured hello interval for the OSPF virtual interface.
Dead Interval The configured dead interval for the OSPF virtual interface.
Retransmit
Interval
The configured retransmit interval for the OSPF virtual interface.
Transit Delay The configured transit delay for the OSPF virtual interface.
Format router rip
Mode Global Config
Default enabled
Format enable
Mode Router RIP Config
To Next Page
Loading...
