Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-138
v1.0, July 2010
10 11 1 65 25 1 1 0
20 1 0 8 2 0 1 1
clear ip arp inspection statistics
Use this command to reset the statistics for Dynamic ARP Inspection on all VLANs.
show ip arp inspection interfaces
Use this command to display the Dynamic ARP Inspection configuration on all the DAI-enabled
interfaces. An interface is said to be enabled for DAI if at least one VLAN, that the interface is a
member of, is enabled for DAI. Given a unit/slot/port interface argument, the command displays
the values for that interface whether the interface is enabled for DAI or not.
Example: The following shows example CLI display output for the command.
(Switch) #show ip arp inspection interfaces
Interface Trust State Rate Limit Burst Interval
(pps) (seconds)
--------------- ----------- ---------- ---------------
0/1 Untrusted 15 1
Default none
Format clear ip arp inspection statistics
Mode Privileged EXEC
Format show ip arp inspection interfaces [unit/slot/port]
Mode • Privileged EXEC
• User EXEC
Term Definition
Interface The interface ID for each displayed row.
Trust State Whether the interface is trusted or untrusted for DAI.
Rate Limit The configured rate limit value in packets per second.
Burst Interval The configured burst interval value in seconds.
To Next Page
Loading...
Need help?
General
