Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-75
v1.0, July 2010
If the interface mode is server, the following information displays.
If the interface mode is relay, the following information displays.
If you use the statistics parameter, the command displays the IPv6 DHCP statistics for the
specified interface. See “show ipv6 dhcp statistics” on page 7-73 for information about the output.
clear ipv6 dhcp
Use this command to clear DHCPv6 statistics for all interfaces or for a specific interface. Use the
<unit/slot/port> parameter to specify the interface.
Mode Shows whether the interface is a IPv6 DHCP relay or server.
Term Definition
Pool Name The pool name specifying information for DHCPv6 server distribution to DHCPv6 clients.
Server
Preference
The preference of the server.
Option Flags Shows whether rapid commit is enabled.
Term Definition
Relay Address The IPv6 address of the relay server.
Relay Interface
Number
The relay server interface in <unit/slot/port> format.
Relay Remote
ID
If configured, shows the name of the relay remote.
Option Flags Shows whether rapid commit is configured.
Format clear ipv6 dhcp {statistics | interface <unit/slot/port> statistics}
Mode Privileged EXEC
Term Definition
To Next Page
Loading...
