NETGEAR GSM7228PS - Address Resolution Protocol (ARP) Commands; Chapter 4 Routing Commands

4-1
v1.0, July 2010
Chapter 4
Routing Commands
This chapter describes the routing commands available in the 7000 series CLI.
The Routing Commands chapter contains the following sections:
• “Address Resolution Protocol (ARP) Commands” on page 4-1
• “IP Routing Commands” on page 4-8
• “Router Discovery Protocol Commands” on page 4-20
• “Virtual LAN Routing Commands” on page 4-24
• “Virtual Router Redundancy Protocol Commands” on page 4-25
• “DHCP and BOOTP Relay Commands” on page 4-34
• “IP Helper Commands” on page 4-37
• “Open Shortest Path First (OSPF) Commands” on page 4-39
• “Routing Information Protocol (RIP) Commands” on page 4-82
• “ICMP Throttling Commands” on page 4-91
Address Resolution Protocol (ARP) Commands
This section describes the commands you use to configure ARP and to view ARP information on
the switch. ARP associates IP addresses with MAC addresses and stores the information as ARP
entries in the ARP cache.
Warning: The commands in this chapter are in one of three functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
• Clear commands clear some or all of the settings to factory defaults.