NETGEAR GSM7228PS - Show Ipv6 Brief

Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-20
v1.0, July 2010
To disable ICMP rate limiting, set burst-interval to zero (0).
no ipv6 icmp error-interval
Use the no form of the command to return burst-interval and burst-size to their default values.
show ipv6 brief
Use this command to display the IPv6 status of forwarding mode and IPv6 unicast routing mode.
Default • burst-interval of 1000 msec.
• burst-size of 100 messages
Format ipv6 icmp error-interval <burst-interval> [<burst-size>]
Mode Global Config
Format no ipv6 icmp error-interval
Mode Global Config
Format show ipv6 brief
Mode Privileged EXEC
Term Definition
IPv6
Forwarding
Mode
Shows whether the IPv6 forwarding mode is enabled.
IPv6 Unicast
Routing Mode
Shows whether the IPv6 unicast routing mode is enabled.
IPv6 Hop Limit Shows the unicast hop count used in IPv6 packets originated by the node. For more
information, see “ipv6 hop-limit” on page 7-10.
ICMPv6 Rate
Limit Error
Interval
Shows how often the token bucket is initialized with burst-size tokens. For more
information, see “ipv6 icmp error-interval” on page 7-19.
ICMPv6 Rate
Limit Burst Size
Shows the number of ICMPv6 error messages that can be sent during one burst-interval.
For more information, see “ipv6 icmp error-interval” on page 7-19.
Maximum
Routes
Shows the maximum IPv6 route table size.