NETGEAR GSM7228PS - Show Switchport Protected; Switchport Protected (Interface Config)

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-53
v1.0, July 2010
switchport protected (Interface Config)
Use this command to add an interface to a protected port group. The <groupid> parameter
identifies the set of protected ports to which this interface is assigned. You can only configure an
interface as protected in one group.
no switchport protected (Interface Config)
Use this command to configure a port as unprotected. The groupid parameter identifies the set
of protected ports to which this interface is assigned.
show switchport protected
This command displays the status of all the interfaces, including protected and unprotected
interfaces.
Note: Port protection occurs within a single switch. Protected port configuration does not
affect traffic between ports on two different switches. No traffic forwarding is
possible between two protected ports.
Default unprotected
Format switchport protected <groupid>
Mode Interface Config
Format no switchport protected <groupid>
Mode Interface Config
Format show switchport protected <groupid>
Mode • Privileged EXEC
• User EXEC
Term Definition
Group ID The number that identifies the protected port group.