NETGEAR GSM7228PS - DVMRP Commands; Ip Dvmrp Metric; Ip Dvmrp(Global Config)

Managed Switch CLI Manual, Release 8.0.3
IP Multicast Commands 5-7
v1.0, July 2010
DVMRP Commands
This section provides a detailed explanation of the Distance Vector Multicast Routing Protocol
(DVMRP) commands.
ip dvmrp(Global Config)
This command sets administrative mode of DVMRP in the router to active.
no ip dvmrp(Global Config)
This command sets administrative mode of DVMRP in the router to inactive.
ip dvmrp metric
This command configures the metric for an interface. This value is used in the DVMRP messages
as the cost to reach this network. This field has a range of 1 to 31.
Protocol The multicast routing protocol by which this entry was created.
Incoming
Interface
The interface on which the packet for this source arrives.
Outgoing
Interface List
The list of outgoing interfaces on which this packet is forwarded.
Default disabled
Format ip dvmrp
Mode Global Config
Format no ip dvmrp
Mode Global Config
Default 1
Format ip dvmrp metric <metric>
Mode Interface Config
Term Definition