Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-27
v1.0, July 2010
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 mld-proxy groups
Interface Index................................ 1/0/3
Group Address Last Reporter Up Time Member State Filter Mode
Sources
------------- -------------- ---------- ----------------- -------------- ----
---
FF1E::1 FE80::100:2.3 00:01:40 DELAY_MEMBER Exclude 2
FF1E::2 FE80::100:2.3 00:02:40 DELAY_MEMBER Include 1
FF1E::3 FE80::100:2.3 00:01:40 DELAY_MEMBER Exclude 0
FF1E::4 FE80::100:2.3 00:02:44 DELAY_MEMBER Include 4
show ipv6 mld-proxy groups detail
Use this command to display information about multicast groups that MLD-Proxy reported.
Last Reporter The IP address of the host that last sent a membership report for the current
group, on the network attached to the MLD-Proxy interface (upstream
interface).
Up Time (in secs) The time elapsed in seconds since last created.
Member State Possible values are:
• Idle_Member. The interface has responded to the latest group
membership query for this group.
• Delay_Member. The interface is going to send a group membership
report to respond to a group membership query for this group.
Filter Mode Possible values are Include or Exclude.
Sources The number of sources attached to the multicast group.
Format show ipv6 mld-proxy groups detail
Mode • Privileged EXEC
• User EXEC
Field Description
To Next Page
Loading...
