NETGEAR GSM7228PS - Show Ipv6 Route Preferences

Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-26
v1.0, July 2010
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 route
IPv6 Routing Table - 3 entries
Codes: C - connected, S - static
O - OSPF Intra, OI - OSPF Inter, OE1 - OSPF Ext 1, OE2 - OSPF Ext 2
ON1 - OSPF NSSA Ext Type 1, ON2 - OSPF NSSA Ext Type 2
S 2001::/64 [10/0] directly connected, Null0
C 2003::/64 [0/0]
via ::, 0/11
S 2005::/64 [1/0]
via 2003::2, 0/11
C 5001::/64 [0/0]
via ::, 0/5
OE1 6001::/64 [110/1]
via fe80::200:42ff:fe7d:2f19, 00h:00m:23s, 0/5
OI 7000::/64 [110/6]
via fe80::200:4fff:fe35:c8bb, 00h:01m:47s, 0/11
show ipv6 route preferences
Use this command to show the preference value associated with the type of route. Lower numbers
have a greater preference. A route with a preference of 255 cannot be used to forward traffic.
Format show ipv6 route preferences
Mode Privileged EXEC
Term Definition
Local Preference of directly-connected routes.
Static Preference of static routes.
OSPF Intra Preference of routes within the OSPF area.
OSPF Inter Preference of routes to other OSPF routes that are outside of the area.
OSPF External Preference of OSPF external routes.