NETGEAR GSM7228PS - Dos-Control All; Dos-Control Sipdip

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-193
v1.0, July 2010
dos-control all
This command enables Denial of Service protection checks globally.
no dos-control all
This command disables Denial of Service prevention checks globally.
dos-control sipdip
This command enables Source IP address = Destination IP address (SIP=DIP) Denial of Service
protection. If the mode is enabled, Denial of Service prevention is active for this type of attack. If
packets ingress with SIP=DIP, the packets will be dropped if the mode is enabled.
no dos-control sipdip
This command disables Source IP address = Destination IP address (SIP=DIP) Denial of Service
prevention.
Default disabled
Format dos-control all
Mode Global Config
Format no dos-control all
Mode Global Config
Default disabled
Format dos-control sipdip
Mode Global Config
Format no dos-control sipdip
Mode Global Config