Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-3
v1.0, July 2010
no https port
Use this command to reset the HTTPs port to the default HTTPS port 443.
authentication timeout
Use this command to configure the authentication timeout. If the user does not enter valid
credentials within this time limit, the authentication page needs to be served again in order for the
client to gain access to the network.
no authentication timeout
Use this command to reset the authentication timeout to the default.
show captive-portal
Use this command to display the status of the captive portal feature.
Format no https port
Mode Captive Portal Configuration mode
Default 300
Format authentication timeout <60-600>
Mode Captive Portal Configuration mode
Default 300
Format no authentication timeout
Mode Captive Portal Configuration mode
Format show captive-portal
Mode Privileged EXEC mode
To Next Page
Loading...
Need help?
General
