Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-23
v1.0, July 2010
IPv6 MLD-Proxy Commands
MLD-Proxy is the IPv6 equivalent of IGMP-Proxy. MLD-Proxy commands allow you to
configure the network device as well as to view device settings and statistics using either serial
interface or telnet session. The operation of MLD-Proxy commands is the same as for IGMP-
Proxy: MLD is for IPv6 and IGMP is for IPv4.MGMD is a term used to refer to both IGMP and
MLD.
ipv6 mld-proxy
Use this command to enable MLD-Proxy on the router. To enable MLD-Proxy on the router, you
must enable multicast forwarding. Also, make sure that there are no other multicast routing
protocols enabled n the router.
no ipv6 mld-proxy
Use this command to disable MLD-Proxy on the router.
Reports Received The number of valid MLD reports received by the router.
Reports Sent The number of valid MLD reports sent by the router.
Leaves Received The number of valid MLD leaves received by the router.
Leaves Sent The number of valid MLD leaves sent by the router.
Bad Checksum MLD Packets The number of bad checksum MLD packets received by the router.
Malformed MLD Packets The number of malformed MLD packets received by the router.
Format ipv6 mld-proxy
Mode Interface Config
Format no ipv6 mld-proxy
Mode Interface Config
Field Description
To Next Page
Loading...
