Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-69
v1.0, July 2010
show ip ospf abr
This command displays the internal OSPF routing table entries to Area Border Routers (ABR).
This command takes no options.
show ip ospf area
This command displays information about the area. The <areaid> identifies the OSPF area that
is being displayed.
Format show ip ospf abr
Mode • Privileged EXEC
• User EXEC
Term Definition
Type The type of the route to the destination. It can be either:
• intra — Intra-area route
• inter — Inter-area route
Router ID Router ID of the destination.
Cost Cost of using this route.
Area ID The area ID of the area from which this route is learned.
Next Hop Next hop toward the destination.
Next Hop Intf The outgoing router interface to use when forwarding traffic to the next hop.
Format show ip ospf area <areaid>
Modes • Privileged EXEC
• User EXEC
Term Definition
AreaID The area id of the requested OSPF area.
External Routing A number representing the external routing capabilities for this area.
Spf Runs The number of times that the intra-area route table has been calculated using this area's
link-state database.
Area Border
Router Count
The total number of area border routers reachable within this area.
Area LSA Count Total number of link-state advertisements in this area's link-state database, excluding AS
External LSA's.
To Next Page
Loading...
