Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-57
v1.0, July 2010
show ipv6 ospf abr
This command displays the internal OSPFv3 routes to reach Area Border Routers (ABR). This
command takes no options.
show ipv6 ospf area
This command displays information about the area. The <areaid> identifies the OSPF area that
is being displayed.
Source Shows source protocol/routes that are being redistributed. Possible values are static,
connected, BGP, or RIP.
Metric The metric of the routes being redistributed.
Metric Type Shows whether the routes are External Type 1 or External Type 2.
Tag The decimal value attached to each external route.
Subnets For redistributing routes into OSPF, the scope of redistribution for the specified protocol.
Distribute-List The access list used to filter redistributed routes.
Format show ipv6 ospf abr
Modes • Privileged EXEC
• User EXEC
Term Definition
Type The type of the route to the destination. It can be either:
• intra — Intra-area route
• inter — Inter-area route
Router ID Router ID of the destination.
Cost Cost of using this route.
Area ID The area ID of the area from which this route is learned.
Next Hop Next hop toward the destination.
Next Hop Intf The outgoing router interface to use when forwarding traffic to the next hop.
Term Definition
To Next Page
Loading...
