Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-8
v1.0, July 2010
Management VLAN ID............................. 1
Web Mode....................................... Enable
Java Mode...................................... Enable
Console Port Access Commands
This section describes the commands you use to configure the console port. You can use a serial
cable to connect a management host directly to the console port of the switch.
configuration
This command gives you access to the Global Config mode. From the Global Config mode, you
can configure a variety of system settings, including user accounts. From the Global Config mode,
you can enter other command modes, including Line Config mode.
line
This command gives you access to the Line Config mode, which allows you to configure various
Telnet settings, ssh settings, and the console port.
serial baudrate
This command specifies the communication rate of the terminal interface. The supported rates are
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
Format configuration
Mode Privileged EXEC
Format line {console | telnet | ssh}
Mode Global Config
Default 9600
Format serial baudrate {1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 57600 |
115200}
Mode Line Config
To Next Page
Loading...
Need help?
General
