Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-187
v1.0, July 2010
TLV Codes: 0- Capabilities, 1- Network Policy
2- Location, 3- Extended PSE
4- Extended Pd, 5- Inventory
--More-- or (q)uit
(Switch) #show lldp med interface 1/0/2
Interface Link configMED operMED ConfigNotify TLVsTx
--------- ------ --------- -------- ------------ -----------
1/0/2 Up Disabled Disabled Disabled 0,1
TLV Codes: 0- Capabilities, 1- Network Policy
2- Location, 3- Extended PSE
4- Extended Pd, 5- Inventory
(Routing) #
show lldp med local-device detail
This command displays detailed information about the LLDP data a specific interface transmits.
Format show lldp med local-device detail <unit/slot/port>
Mode Privileged EXEC
Term Definition
Media Application
Type
Shows the application type. Types are unknown, voice, voicesignaling, guestvoice,
guestvoicesignaling, sfotphonevoice, videoconferencing, streamingvideo,
videosignaling.
Vlan ID Shows the VLAN id associated with a particular policy type
Priority Shows the priority associated with a particular policy type.
DSCP Shows the DSCP associated with a particular policy type.
Unknown Indicates if the policy type is unknown. In this case, the VLAN ID, Priority and DSCP
are ignored.
Tagged Indicates if the policy type is using tagged or untagged VLAN.
Hardware Rev Shows the local hardware version.
Firmware Rev Shows the local firmware version.
Software Rev Shows the local software version.
Serial Num Shows the local serial number.
Mfg Name Shows the manufacture name.
Model Name Shows the model name.
To Next Page
Loading...
Need help?
General
