NETGEAR GSM7228PS - Clear Ipv6 Ospf Neighbor Interface; Clear Ipv6 Ospf Redistribution; Default-Information Originate (Ospfv)

Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-47
v1.0, July 2010
clear ipv6 ospf neighbor interface
To drop adjacency with all neighbors on a specific interface, use the optional parameter [unit/slot/
port]. To drop adjacency with a specific router ID on a specific interface, use the optional
parameter [neighbor-id].
clear ipv6 ospf redistribution
Use this command to flush all self-originated external LSAs. Reapply the redistribution
configuration and re-originate prefixes as necessary.
default-information originate (OSPFv3)
This command is used to control the advertisement of default routes.
no default-information originate (OSPFv3)
This command is used to control the advertisement of default routes.
Format clear ipv6 ospf neighbor interface [unit/slot/port] [neighbor-id]
Mode Privileged EXEC
Format clear ipv6 ospf redistribution
Mode Privileged EXEC
Default • metric—unspecified
• type—2
Format default-information originate [always] [metric <1-16777214>] [metric-
type {1 | 2}]
Mode Router OSPFv3 Config
Format no default-information originate [metric] [metric-type]
Mode Router OSPFv3 Config