NETGEAR GSM7228PS - Show Supported Switchtype

Managed Switch CLI Manual, Release 8.0.3
Stacking Commands 2-9
v1.0, July 2010
show supported switchtype
This commands displays information about all supported switch types or a specific switch type.
If you do not supply a value for <switchindex>, the following output appears:
If you supply a value for <switchindex>, the following output appears:
Switch Status The switch status. Possible values are OK, Unsupported, Code Mismatch, Config
Mismatch, or Not Present.
Switch
Description
The switch description.
Expected Code
Version
The expected code version.
Detected Code
Version
The version of code running on this switch. If the switch is not present and the data is
from pre-configuration, then the code version is “None”.
Detected Code in
Flash
The version of code that is currently stored in FLASH memory on the switch. This code
executes after the switch is reset. If the switch is not present and the data is from pre-
configuration, then the code version is “None”.
Up Time The system up time.
Format show supported switchtype [<switchindex>]
Mode User EXEC
Privileged EXEC
Term Definition
Switch Index (SID) The index into the database of supported switch types. This index is used when
preconfiguring a member to be added to the stack.
Model Identifier The model identifier for the supported switch type.
Management
Preference
The management preference value of the switch type.
Code Version The code load target identifier of the switch type.
Term Definition
Switch Type The 32-bit numeric switch type for the supported switch.
Term Definition