NETGEAR GSM7228PS - Snmp-Server Community Rw; Snmp-Server Enable Traps Violation

Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-44
v1.0, July 2010
snmp-server community rw
This command restricts access to switch information. The access mode is read/write (also called
private).
snmp-server enable traps violation
This command enables the sending of new violation traps designating when a packet with a
disallowed MAC address is received on a locked port.
no snmp-server enable traps violation
This command disables the sending of new violation traps.
snmp-server enable traps
This command enables the Authentication Flag.
Format snmp-server community rw <name>
Mode Global Config
Note: For other port security commands, see “Protected Ports Commands” on page 3-52.
Default disabled
Format snmp-server enable traps violation
Mode Interface Config
Format no snmp-server enable traps violation
Mode Interface Config
Default enabled
Format snmp-server enable traps
Mode Global Config