NETGEAR GSM7228PS - Set Mld Querier Query_Interval

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-163
v1.0, July 2010
no set mld querier
Use this command to disable MLD Snooping Querier on the system. Use the optional parameter
address to reset the querier address.
set mld querier query_interval
Use this command to set the MLD Querier Query Interval time. It is the amount of time in seconds
that the switch waits before sending another general query.
no set mld querier query_interval
Use this command to set the MLD Querier Query Interval time to its default value.
Format set mld querier <address ipv6_address>
Mode • Global Config
Default disabled
Format set mld querier [<vlan-id>] [address ipv6_address]
Mode • VLAN Mode
Format no set mld querier address
Mode • Global Config
Format no set mld querier <vlan-id> address <ipv6_address>
Mode • VLAN Mode
Default disabled
Format set mld querier query_interval <1-18000>
Mode Global Config
Format no set mld querier query_interval
Mode Global Config