Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-130
v1.0, July 2010
Example: The following shows example CLI display output for the command.
(switch) #show ip verify source
Interface Filter Type IP Address MAC Address Vlan
--------- ----------- --------------- ----------------- -----
0/1 ip-mac 210.1.1.3 00:02:B3:06:60:80 10
0/1 ip-mac 210.1.1.4 00:0F:FE:00:13:04 10
show ip source binding
Use this command to display the IPSG bindings.
Filter Type Is one of two values:
• ip-mac: User has configured MAC address filtering on this interface.
• ip: Only IP address filtering on this interface.
IP Address IP address of the interface
MAC Address If MAC address filtering is not configured on the interface, the MAC Address field is
empty. If port security is disabled on the interface, then the MAC Address field displays
“permit-all.”
VLAN The VLAN for the binding rule.
Format show ip source binding [{static/dynamic}] [interface unit/slot/port]
[vlan id]
Mode • Privileged EXEC
• User EXEC
Term Definition
MAC Address The MAC address for the entry that is added.
IP Address The IP address of the entry that is added.
Type Entry type; statically configured from CLI or dynamically learned from DHCP Snooping.
VLAN VLAN for the entry.
Interface IP address of the interface in unit/slot/port format.
Term Definition
To Next Page
Loading...
Need help?
General
