Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-15
v1.0, July 2010
MbufsFree 150
MbufsRxUsed 0
Total Rx Norm Alloc Attempts 26212
Total Rx Mid2 Alloc Attempts 4087
Total Rx Mid1 Alloc Attempts 188943
Total Rx High Alloc Attempts 384555
Total Tx Alloc Attempts 2478536
Total Rx Norm Alloc Failures 0
Total Rx Mid2 Alloc Failures 0
Total Rx Mid1 Alloc Failures 0
Total Rx High Alloc Failures 0
Total Tx Alloc Failures 0
show running-config
Use this command to display or capture the current setting of different protocol packages
supported on the switch. This command displays or captures commands with settings and
configurations that differ from the default value. To display or capture the commands with settings
and configurations that are equal to the default value, include the [all] option.
The output is displayed in script format, which can be used to configure another switch with the
same configuration. If the optional <scriptname> is provided with a file name extension of
“.scr”, the output is redirected to a script file.
Note: Show running-config does not display the User Password, even if you set one
different from the default.
Note: If you issue the show running-config command from a serial connection, access to
the switch through remote connections (such as Telnet) is suspended while the
output is being generated and displayed.
Note: If you use a text-based configuration file, the show running-config
command will only display configured physical interfaces, i.e. if any interface only
contains the default configuration, that interface will be skipped from the show
running-config command output. This is true for any configuration mode that
contains nothing but default configuration. That is, the command to enter a
particular config mode, followed immediately by its ‘exit’ command, are both
omitted from the show running-config command output (and hence from
the startup-config file when the system configuration is saved.)
To Next Page
Loading...
Need help?
General
