NETGEAR GSM7228PS - Ipv6 Ospf Cost; Ipv6 Ospf Dead-Interval

Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-34
v1.0, July 2010
ipv6 ospf cost
This command configures the cost on an OSPF interface. The <cost> parameter has a range of 1
to 65535.
no ipv6 ospf cost
This command configures the default cost on an OSPF interface.
ipv6 ospf dead-interval
This command sets the OSPF dead interval for the specified interface. The value for <seconds>
is a valid positive integer, which represents the length of time in seconds that a router's Hello
packets have not been seen before its neighbor routers declare that the router is down. The value
for the length of time must be the same for all routers attached to a common network. This value
should be some multiple of the Hello Interval (i.e., 4). Valid values range for <seconds> is from
1 to 2147483647.
no ipv6 ospf dead-interval
This command sets the default OSPF dead interval for the specified interface.
Default 10
Format ipv6 ospf cost <1-65535>
Mode Interface Config
Format no ipv6 ospf cost
Mode Interface Config
Default 40
Format ipv6 ospf dead-interval <seconds>
Mode Interface Config
Format no ipv6 ospf dead-interval
Mode Interface Config