NETGEAR GSM7228PS - Dot1 X Max-Req; Dot1 X Max-Users

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-66
v1.0, July 2010
dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will
transmit an EAPOL EAP Request/Identity frame before timing out the supplicant. The <count>
value must be in the range 1 - 10.
no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will
transmit an EAPOL EAP Request/Identity frame before timing out the supplicant.
dot1x max-users
Use this command to set the maximum number of clients supported on the port when MAC-based
dot1x authentication is enabled on the port. The maximum users supported per port is dependent
on the product. The <count> value is in the range 1 - 16.
no dot1x max-users
This command resets the maximum number of clients allowed per port to its default value.
Default 2
Format dot1x max-req
<count>
Mode Interface Config
Format no dot1x max-req
Mode Interface Config
Default 16
Format dot1x max-users
<count>
Mode Interface Config
Format no dot1x max-req
Mode Interface Config