NETGEAR GSM7228PS - Show Ip Pimsm; Show Ip Pimsm Bsr

Managed Switch CLI Manual, Release 8.0.3
IP Multicast Commands 5-23
v1.0, July 2010
show ip pimsm
This command displays the system-wide information for PIM-SM.
show ip pimsm bsr
This command displays the bootstrap router (BSR) information. The output includes elected BSR
information and information about the locally configured candidate rendezvous point (RP)
advertisement.
Format show ip pimsm
Modes • Privileged EXEC
• User EXEC
Term Definition
Admin Mode Indicates whether PIM-SM is enabled or disabled.
Data Threshold
Rate (Kbps)
The data threshold rate for the PIM-SM router.
Register
Threshold Rate
(Kbps)
The threshold rate for the RP router to switch to the shortest path.
Interface Valid unit, slot, and port number separated by forward slashes.
Interface-Mode Indicates whether PIM-SM is enabled or disabled on the interface.
Operational-
Status
The current state of the PIM-SM protocol on the interface. Possible values are
Operational or Non-Operational.
Format show ip pimsm bsr
Mode • Privileged EXEC
• User EXEC
Term Definition
BSR Address IP address of the BSR.
Uptime Length of time that this router has been up (in hours, minutes, and seconds).
BSR Priority Priority as configured in the ip pimsm bsr-candidate command.
Hash Mask
Length
Length of a mask (maximum 32 bits) that is to be ANDed with the group address before
the hash function is called. This value is configured in the ip pimsm bsr-candidate
command.