NETGEAR GSM7228PS - Ip Dhcp Snooping Binding; Ip Dhcp Snooping Database Write-Delay

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-122
v1.0, July 2010
ip dhcp snooping database write-delay
Use this command to configure the interval in seconds at which the DHCP Snooping database will
be persisted. The interval value ranges from 15 to 86400 seconds.
no ip dhcp snooping database write-delay
Use this command to set the write delay value to the default value.
ip dhcp snooping binding
Use this command to configure static DHCP Snooping binding.
no ip dhcp snooping binding <mac-address>
Use this command to remove the DHCP static entry from the DHCP Snooping database.
Default local
Format ip dhcp snooping database {local|tftp://hostIP/filename}
Mode Global Config
Default 300 seconds
Format ip dhcp snooping database write-delay <in seconds>
Mode Global Config
Format no ip dhcp snooping database write-delay
Mode Global Config
Format ip dhcp snooping binding <mac-address> vlan <vlan id> <ip address>
interface <interface id>
Mode Global Config