NETGEAR GSM7228PS - Ipv6 Pimdm Hello-Interval; Show Ipv6 Pimdm

Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-5
v1.0, July 2010
no ipv6 pimdm
Use this command to administratively disable PIM-DM Multicast Routing Mode either across the
router (Global Config) or on a particular router (Interface Config).
ipv6 pimdm hello-interval
Use this command to configure the PIM-DM hello interval for the specified router interface. The
hello-interval is specified in seconds and is in the range 10–3600.
no ipv6 pimdm hello-interval
Use this command to set the PIM-DM hello interval to the default value.
show ipv6 pimdm
Use this command to display PIM-DM Global Configuration parameters and PIM-DM interface
status.
Default disabled
Format ipv6 pimdm
Mode • Global Config
• Interface Config
Format no ipv6 pimdm
Mode • Global Config
• Interface Config
Default 30
Format ipv6 pimdm hello-interval <10-3600>
Mode Interface Config
Format no ipv6 pimdm hello-interval
Mode Interface Config