Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-2
v1.0, July 2010
no enable
Use this command to globally disable captive portal.
http port
Use this command to configure an additional HTTP port for captive portal to monitor. The valid
range is from 0 to 65535.
no http port
Use this command to reset the HTTP port to the default number 80.
https port
Use this command to configure an additional HTTPS port for captive portal to monitor. The valid
range is from 0 to 65535.
Default disabled
Format no enable
Mode Captive Portal Configuration mode
Default 80
Format http port <0-65535>
Mode Captive Portal Configuration mode
Format no http port
Mode Captive Portal Configuration mode
Default 443
Format https port <0-65535>
Mode Captive Portal Configuration mode
To Next Page
Loading...
