NETGEAR GSM7228PS - Captive Portal Interface Commands; Captive-Portal Client Deauthenticate; Show Captive-Portal Interface Configuration Status

Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-23
v1.0, July 2010
If the CP ID is specified, the following terms are displayed.
Example
(switch)#show captive-portal configuration client status
CP ID CP Name Client MAC Address Client IP Address Interface
----- ------- ------------------ ----------------- ---------
1 cp1 0002.BC00.1290 10.254.96.47 1/0/1
2 cp2 0002.BC00.1292 10.254.96.49 1/0/3
3 cp3 0002.BC00.1293 10.254.96.50 1/0/4
(switch)#show captive-portal configuration 1 client status
CP ID..................................... 1
CP Name................................... cp1
Client Client
MAC Address IP Address Interface Interface Description
-------------- ------------- --------- ----------------------
0002.BC00.1290 10.254.96.47 1/0/1 Unit:1 Slot:0 Port:1 Gigabit
0002.BC00.1291 10.254.96.48 1/0/2 Unit:1 Slot:0 Port:2 Gigabit
captive-portal client deauthenticate
Use this command to deauthenticate a specific captive portal client. The macaddr is the
Client MAC address.
Captive Portal Interface Commands
The following section describes captive portal interface commands.
show captive-portal interface configuration status
Use this command to display the interface to configuration assignments for all captive portal
configurations or for a specific configuration. <1-10> is the captive portal ID.
Term Definition
Interface
Description
The description of the interace
Format captive-portal client deauthenticate macaddr
Mode Privileged EXEC mode