NETGEAR GSM7228PS - Show Sntp Server

Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-39
v1.0, July 2010
show sntp server
This command is used to display SNTP server settings and configured servers.
For each configured server:
Term Definition
Client Supported
Modes
Supported SNTP Modes (Broadcast, Unicast, or Multicast).
SNTP Version The highest SNTP version the client supports.
Port SNTP Client Port.
Client Mode Configured SNTP Client Mode.
Format show sntp server
Mode Privileged EXEC
Term Definition
Server Host
Address
IP address or hostname of configured SNTP Server.
Server Type Address Type of Server.
Server Stratum Claimed stratum of the server for the last received valid packet.
Server
Reference ID
Reference clock identifier of the server for the last received valid packet.
Server Mode SNTP Server mode.
Server Maximum
Entries
Total number of SNTP Servers allowed.
Server Current
Entries
Total number of SNTP configured.
Term Definition
Host Address IP address or hostname of configured SNTP Server.
Address Type Address Type of configured SNTP server.
Priority IP priority type of the configured server.
Version SNTP Version number of the server. The protocol version used to query the server in
unicast mode.
Port Server Port Number.