Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-35
v1.0, July 2010
vlan participation all
This command configures the degree of participation for all interfaces in a VLAN. The ID is a
valid VLAN identification number.
You can use the following participation options:
vlan port acceptframe all
This command sets the frame acceptance mode for all interfaces.
The modes defined as follows:
With either option, VLAN tagged frames are forwarded in accordance with the IEEE 802.1Q
VLAN Specification.
Format vlan participation all {exclude | include | auto} <1-4093>
Mode Global Config
Participation
Options
Definition
include The interface is always a member of this VLAN. This is equivalent to registration fixed.
exclude The interface is never a member of this VLAN. This is equivalent to registration
forbidden.
auto The interface is dynamically registered in this VLAN by GVRP. The interface will not
participate in this VLAN unless a join request is received on this interface. This is
equivalent to registration normal.
Default all
Format vlan port acceptframe all {vlanonly | all}
Mode Global Config
Mode Definition
VLAN Only
mode
Untagged frames or priority frames received on this interface are discarded.
Admit All mode Untagged frames or priority frames received on this interface are accepted and assigned
the value of the interface VLAN ID for this port.
To Next Page
Loading...
Need help?
General
