Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-90
v1.0, July 2010
show ip rip interface
This command displays information related to a particular RIP interface.
The following information will be invalid if the link state is down.
Receive Version The RIP version(s) allowed when receiving updates from the specified interface. The
types are none, RIP-1, RIP-2, Both
RIP Mode The administrative mode of router RIP operation (enabled or disabled).
Link State The mode of the interface (up or down).
Format show ip rip interface {<unit/slot/port> | vlan <1-4093>}
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Valid unit, slot, and port number separated by forward slashes. This is a configured value.
IP Address The IP source address used by the specified RIP interface. This is a configured value.
Send Version The RIP version(s) used when sending updates on the specified interface. The types are
none, RIP-1, RIP-1c, RIP-2. This is a configured value.
Receive Version The RIP version(s) allowed when receiving updates from the specified interface. The
types are none, RIP-1, RIP-2, Both. This is a configured value.
RIP Admin Mode RIP administrative mode of router RIP operation; enable activates, disable de-activates it.
This is a configured value.
Link State Indicates whether the RIP interface is up or down. This is a configured value.
Authentication
Type
The RIP Authentication Type for the specified interface. The types are none, simple, and
encrypt. This is a configured value.
Default Metric A number which represents the metric used for default routes in RIP updates originated
on the specified interface. This is a configured value.
Term Definition
Bad Packets
Received
The number of RIP response packets received by the RIP process which were
subsequently discarded for any reason.
Bad Routes
Received
The number of routes contained in valid RIP packets that were ignored for any reason.
Updates Sent The number of triggered RIP updates actually sent on this interface.
Term Definition
To Next Page
Loading...
Need help?
General
