Managed Switch CLI Manual, Release 8.0.3
IP Multicast Commands 5-35
v1.0, July 2010
IGMP Proxy Commands
The IGMP Proxy is used by IGMP Router (IPv4 system) to enable the system to issue IGMP host
messages on behalf of hosts that the system discovered through standard IGMP router interfaces.
With IGMP Proxy enabled, the system acts as proxy to all the hosts residing on its router
interfaces.
ip igmp-proxy
This command enables the IGMP Proxy on the router. To enable the IGMP Proxy on the router,
you must enable multicast forwarding. Also, make sure that there are no multicast routing
protocols enabled on the router.
no ip igmp-proxy
This command disables the IGMP Proxy on the router.
ip igmp-proxy unsolicit-rprt-interval
This command sets the unsolicited report interval for the IGMP Proxy router. This command is
valid only when you enable IGMP Proxy on the interface. The value of <interval> can be 1-
260 seconds.
Format ip igmp-proxy
Mode Interface Config
Format no ip igmp-proxy
Mode Interface Config
Default 1
Format ip igmp-proxy unsolicit-rprt-interval <interval>
Mode Interface Config
To Next Page
Loading...
