Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-40
v1.0, July 2010
protocol vlan group all
This command adds all physical interfaces to the protocol-based VLAN identified by
<groupid>. You can associate multiple interfaces with a group, but you can only associate each
interface and protocol combination with one group. If adding an interface to a group causes any
conflicts with protocols currently associated with the group, this command will fail and the
interface(s) will not be added to the group.
no protocol vlan group all
This command removes all interfaces from this protocol-based VLAN group that is identified by
this <groupid>.
vlan pvid
This command changes the VLAN ID per interface.
no vlan pvid
This command sets the VLAN ID per interface to 1.
Default none
Format protocol vlan group all <groupid>
Mode Global Config
Format no protocol vlan group all <groupid>
Mode Global Config
Default 1
Format vlan pvid <1-4093>
Mode Interface Config
Format no vlan pvid
Mode Interface Config
To Next Page
Loading...
